Sony DNW-7/7P Operation Manual page 186

2
• To enable the write-protection function (the "ON" setting), turn
the rotary encoder counterclockwise as seen from the front of the
camera.
• To disable the write-protection function (the "OFF" setting), turn
the rotary encoder clockwise.
If data cannot be written
If when you press the rotary encoder in step 6 of the foregoing procedure
(page 4-105) one of the following error messages appears, then the data
4
was not written.
Error message
CARD NOT
INSERTED!
WRITE
PROTECTED!
WRITE ERROR!
(flashing)
Reading saved data from a card
Follow the procedure below.
1,2,7
2,3,4,6
4-108
Chapter 4 Adjustments and Settings for Recording
Data write error messages
Reason
No setup card is
inserted.
WRITE PROTECT
is set to ON.
Circuit or card fault
Reading saved data from a card
Action
Close the menu and insert or
reinsert the card.
Set WRITE PROTECT to OFF.
Check the circuitry, or replace the
card with a verified card.
3,5