2
Push the MENU ON/OFF/PAGE switch repeatedly to PAGE until
the SETUP CARD page shown below appears (or use the rotary
encoder).
m
4
a) Displayed in engineer mode only
If no card is inserted, the message "CARD NOT INSERTED!"
appears. Close the menu and insert a card.
3
Push the MENU CANCEL/PRST/ITEM switch repeatedly to ITEM
until the cursor reaches the WRITE (
rotary encoder).
4
Press the rotary encoder.
A message asking whether or not data and the card ID of the camera
are to be written to the card appears.
4-104
Chapter 4 Adjustments and Settings for Recording
SETUP CARD
READ (mCAM)
WRITE (mCARD)
ID EDIT
WRITE PROTECT
: OFF
PRESS:READ CARD
SETUP CARD page (factory settings)
Data read message
Data write message
Setting of card ID
Setting of write protection
function
CARD) position (or use the
a)