Table of Contents
Advertisement
Table 2: Interface Mapping (continued)
Port Label
Interface
MGMT
fxp0
Table 3: LTE Interfaces
Interface
cl-1/1/0
dl0 (logical)
The NFX150 device is shipped with the following services enabled by default: DHCP, HTTPS, and TFTP.
To provide secure traffic, a basic set of screens are configured on the untrust zone.
Access the Device
Ensure that the NFX150 device is powered on.
1.
Connect to the console port:
2.
Plug one end of the Ethernet cable into the console port on your NFX150 device.
a.
Connect the other end of the Ethernet cable to the RJ-45—to—DB-9 serial port adapter shipped with your device.
b.
Connect the RJ-45—to—DB-9 serial port adapter to the serial port on the management device. Use the following values
c.
to configure the serial port:
Baud rate—9600; Parity—N; Data bits—8; Stop bits—1; Flow control—None.
NOTE:
Alternately, you can use the USB cable to connect to the mini-USB console port on the device. To use the
mini-USB console port, you must download the USB driver from the following page and install it on the management
device:
https://www.juniper.net/support/downloads/junos.html
Use any terminal emulation program, such as HyperTerminal, to connect to the device console. The CLI displays a login prompt.
3.
Log in as root and enter the password juniper123. If the software completes booting before you connect to the console, you
4.
might need to press the
login: root
password: juniper123
Start the CLI:
5.
root@:~ # cli
root@>
Enter configuration mode:
6.
root@> configure
[edit]
Copyright © 2018, Juniper Networks, Inc.
Virtual Interface
N/A
Security Zone
N/A
untrust
key for the prompt to appear:
Enter
NFX150-S1 Network Services Platform Quick Start
Security Zone
DHCP State
N/A
N/A
IP Address
N/A
ISP assigned
IP Address
192.168.1.1/24
5
Advertisement
Table of Contents
