Adding An Audio Sound On A Recorded Tape - Sony DCR PC 8 E Operating Instructions Manual

Audio dubbing
Adding an audio sound on a
recorded tape
(1) Insert your recorded tape into your
camcorder.
(2) Set the POWER switch to VCR.
(3) Locate the recording start point. Press the
/N button to start playing back. To
pause playing back, press the
at the recording start point. You can fine
adjust the recording start point by pressing
/ button, and you can also use the
Remote Commander for this operation.
(4) Press FN and select PAGE3.
(5) Press A DUB CTRL to display control buttons.
(6) Press AUDIO DUB. The green
on the LCD screen.
(7) Press on your camcorder and at the
same time start playing back the audio you
want to record.
The new sound is recorded in stereo 2 (ST2)
during playback. During recording new
sound, the red appears on the LCD screen.
(8) Press
on your camcorder at the point
where you want to stop recording.
4
PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT
DATA DATA DATA DATA DATA DATA DATA DATA V SPD XXXX XXXX XXXX XXXX XXXX XXXX XXXX AUDIO A DUB AUDIO AUDIO AUDIO AUDIO AUDIO AUDIO
CODE CODE CODE CODE CODE CODE CODE CODE XXXX XXXX XXXX XXXX XXXX XXXX XXXX PLAY CTRL DUB DUB DUB DUB DUB DUB DUB
/X button
X appears
AUDIO DUB
REC REC REC REC REC REC REC REC
CTRL CTRL CTRL CTRL CTRL CTRL CTRL CTRL
REC REC REC REC REC REC REC
PAUSE PAUSE PAUSE PAUSE PAUSE PAUSE PAUSE
(1)
(2)
(3)
N
(4)
(5)
(6)
X
(7)
(8)
RET. RET. RET. RET. RET. RET. RET. RET.
AUDIO REC REC REC REC REC REC REC
START START START START START START START DUB
X
3
FN
121