To Perform Fine Adjustment Of Print Ratio For Front Side At Duplex Printing - Toshiba e-Studio6506AC Imaging Manual

3. Printer-specific Adjustments
3.30 To Perform Fine Adjustment of Print Ratio for Front Side at
Duplex Printing
□ Explanation
Perform this fine adjustment if the deviation in the printing positions between the front and back sides of the
output is conspicuous due to the differences in the image size during duplex printing of a business card or
postcard.
By performing fine adjustment of the print ratio at the front side in each of the primary and secondary scanning
directions, the image size of the front side can be made to be close that for the back side and thus the deviation in
the printing positions can be reduced.
□ Procedures
* The service technician must perform the adjustment or the MFP administrator (user) can perform the
adjustment by being instructed from the service technician.
Notes:
* This adjustment is performed when the print ratio between the front and back sides is not equal and thus
the deviation between them in the printing position still persists after that in duplex printing has been
adjusted in accordance with "1.6 To Adjust Printing Positions on Front and Back Sides in Duplex Mode".
* When this adjustment is performed, the image position at the trailing edge will be changed while the start
position is taken as a standard in both the primary and secondary directions.
* Printing only from the following Windows printer drivers is supported for this adjustment, but printing
from other than the printer driver, such as e-Filing Box or USB, does not reflect this adjustment.
TOSHIBA Universal Printer2 (PCL6, PS)
TOSHIBA Universal PS3
TOSHIBA Universal XPS
- It is recommended to explain to users that the duplex printing speed will be lowered for the paper type for
which this adjustment is performed.
- Depending on the hygroscopic condition of the paper, its size will be changed in duplex printing and thus
the image sizes between the front and back sides will deviate. In such a case, reattempt the adjustment as
required.
e-STUDIO5506AC/6506AC/7506AC (Ver01)
a: Primary scanning direction
b: Secondary scanning direction
F: Front side (the side to which the print
ratio is adjusted)
R: Back side
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-146