Configuring Simocode Pro V Pn Ports - Siemens SIMOCODE pro Function Manual

Module replacement without exchangeable medium/PC
Note
Precondition for module replacement without exchangeable medium/PC
The use of this function depends whether the IO controller and the neighboring IO devices
support this function.
Assuming SIMOCODE pro in STEP 7 V5 has been integrated and parameterized using
OM SIMOCODE pro, the IO controller can automatically restore the device name, the IP
configuration, and then the complete device parameterization performed with
SIMOCODE ES of the replaced device.
Note
Do not use a memory module or initialization module!
To use this function, you do not have to and indeed must not use of a memory module or an
initialization module!
For further information, see Chapter "Restoring factory settings" in SIMOCODE pro –
System Manual (https://support.industry.siemens.com/cs/ww/en/view/109743957).
2.2.8

Configuring SIMOCODE pro V PN ports

Configuring the ports
SIMOCODE pro V PN (GP) has two RJ45 ports labeled 1 and 2 on the front. In the
configuration tool of the automation system (e.g. STEP 7 HW Config), the settings for
topology, diagnostics and other options of the two ports X1P1 and X1P2 are defined.
SIMOCODE pro - Communication
Function Manual, 11/2018, A5E40508495002A/RS-AC/003
Communication
2.2 PROFINET communication
53