Integration Of Simocode Pro In Dp Master Systems; Slave Operating Modes; Preparing The Data Transfer - Siemens SIMOCODE pro Function Manual

Communication
2.1 PROFIBUS communication
2.1.5

Integration of SIMOCODE pro in DP master systems

2.1.5.1

Slave operating modes

The following table shows an overview of the slave operating modes with which SIMOCODE
pro can be operated on the class 1 master:
Table 2- 8 Slave operating modes of SIMOCODE pro
SIMOCODE pro
integrated as
DPV1 slave via GSD
S7 slave via
OM SIMOCODE pro
2.1.5.2

Preparing the data transfer

The precondition for communication with a master class 1 (PLC) is integration according to
table "Slave modes of SIMOCODE pro" and the setting for the PROFIBUS DP address.
You will find information about setting the address in Chapter "Setting the PROFIBUS DP
address" in Chapter "Commissioning and service" in the system manual.
28
Non-vendor-specific DP master,
without DPV1 interrupts
Cyclic data exchange
•
Standard diagnostics
•
Status information
•
Parameterization during
•
starting (SIMOCODE pro C
basic unit only)
Acyclic writing and reading of
•
DPV1 data records
(if supported by the master)
—
Class 1 master
Non-vendor-specific DP
master, with DPV1 interrupts
Cyclic data exchange
•
Standard diagnostics
•
Status information
•
Hardware and diagnostic
•
interrupts
Parameterization during
•
starting
(SIMOCODE pro C basic
unit only)
Acyclic reading and writing
•
of DPV1 data records
—
Function Manual, 11/2018, A5E40508495002A/RS-AC/003
S7 master
Cyclic data exchange
•
Standard diagnostics
•
Status information
•
Hardware and diagnostic
•
interrupts
Parameterization during
•
starting
(SIMOCODE pro C basic
unit only)
Acyclic reading and
•
writing of DPV1 data
records
Cyclic data exchange
•
Standard diagnostics
•
Hardware and diagnostic
•
interrupts
Parameterization during
•
startup
Acyclic reading and
•
writing of DPV1 data
records
SIMOCODE pro - Communication