Table 23 Fields In Menu 15.1.1 - Nortel BCM50e Configuration

have already configured rules 1 to 6 in your current set and now you configure
rule number 9. In the set summary screen, the new rule will be rule 7, not 9.
If you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5
becomes rule 4, old rule 6 becomes rule 5 and old rule 7 becomes rule 6.

Table 23 Fields in menu 15.1.1

Field Description
Set Name Enter a name for this set of rules. This is a required field. If
this field is left blank, the entire set is deleted.
Action The default is Edit. Edit means you want to edit a selected
rule (see following field). Insert Before means to insert a rule
before the rule selected. The rules after the selected rule are
then moved down by one rule. Delete means to delete the
selected rule and all the rules after the selected one advance
one rule. None disables the Select Rule item.
Select Rule When you choose Edit, Insert Before or Delete in the
previous field, the cursor jumps to this field so you can select
the rule to apply the action in question.
Note: You must press [ENTER] at the bottom of the screen to save the
whole set. You must do this again if you make any changes to the set –
including deleting a rule. No changes to the set take place until this
action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the menu
shown in Figure 37, Menu 15.1.1.1 - Address Mapping Rule in which you can
edit an individual rule and configure the Type, Local and Global Start/End IPs.
Note: An IP End address must be numerically greater than its
corresponding IP Start address.
Chapter 9 Network Address Translation (NAT) 97
BCM50e Integrated Router Configuration - Advanced
Example
NAT_SET
Edit
1