Mounting The Versalar 15000 In An Optional 23-Inch Rack - Nortel Versalar 15000 Installing And Maintaining

Installing and Maintaining the Versalar Switch Router 15000

Mounting the Versalar 15000 in an Optional 23-Inch Rack

To install the Versalar 15000 in a 23-inch four-post rack:
Measure at least 27 in. (68.6 cm) of free vertical space inside the rack and
1.
mark the spot.
Mount the angle brackets supplied with the 23-inch rack mount kit
2.
horizontally in the area indicated in
Note: The angle brackets supplied with the 23-inch rack mount kit are wider
than the angle brackets supplied with the chassis.
Using a Phillips screwdriver, remove the 5 screws securing each of the two
3.
vertical flanges to the Versalar 15000
Using the 8 screws that you removed from the vertical flanges, install the
4.
flanges supplied with the 23-inch rack mount kit as shown in Figure 2-7.
If the holes in the rack's vertical supports are not threaded for cagenut
5.
screws, insert a cagenut in five locations.
Holding the Versalar 15000 in position, align the flanges with two holes
6.
on each side of the vertical rack support
It is easiest to complete this step with two people. Make sure that the hole
pairs on either side of the vertical support match horizontally.
Insert a cagenut screw through each flange hole and into the
7.
corresponding hole in the rack.
Tighten each cagenut screw with a Phillips screwdriver.
8.
2-16
Figure 2-6.
(Figure 2-7). Discard the flanges.
(Figure 2-8).
308684-B Rev 00