Figure 28 Menu 12. 1: Edit Ip Static Route; Table 19 Ip Static Route Menu Fields - Nortel BCM50e Configuration

84 Chapter 7 IP Static Route Setup
Now, enter the index number of the static route that you want to configure.

Figure 28 Menu 12. 1: Edit IP Static Route

Menu 12.1 - Edit IP Static Route
Route #: 2
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to CONFIRM or ESC to CANCEL:
Table 19

Table 19 IP Static Route Menu Fields

Field
Route #
Route Name
Active
Destination IP
Address
IP Subnet Mask Enter the IP subnet mask for this destination.
Gateway IP
Address
N0115789
12. ________
Enter selection number:
describes the IP Static Route Menu fields.
Description
This is the index number of the static route that you chose in menu 12.
Enter a descriptive name for this route. This is for identification
purposes only.
This field allows you to activate or deactivate this static route.
This parameter specifies the IP network address of the final
destination. Routing is always based on network number. If you need to
specify a route to a single host, use a subnet mask of 255.255.255.255
in the subnet mask field to force the network number to be identical to
the host ID.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your Business Secure Router that forwards the packet to
the destination. On the LAN, the gateway must be a router on the same
segment as your Business Secure Router; over the WAN, the gateway
must be the IP address of one of the remote nodes.