Garmin G1000 Reference Manual page 73

4) If the aircraft is on the ground, select the STANDBY Softkey to initiate the
one minute warm-up period. After the warm-up is complete, the radar will
enter the Standby Mode. After the aircraft is airborne, select the WEATHER
Softkey.
Or:
If the aircraft is already airborne, select the WEATHER or GROUND
Softkey. The one-minute warm-up period will be initiated, after which the
radar will begin transmitting. The horizontal scan is initially displayed.
5) Turn the Joystick to select the desired range.
6) If desired, select the VERTICAL Softkey for vertical scanning.
Adjusting Antenna Tilt
Move the Joystick up or down to adjust the tilt of the antenna up or down. Moni-
tor the displayed tilt value in the TILT field.
When scanning vertically, a Tilt Line may be displayed to aid in positioning the tilt
of the antenna. If the Tilt Line is not displayed, perform the following steps:
1) Press the MENU Key
2) Turn the large FMS Knob to select 'Show Tilt Line'.
3) Press the ENT Key.
Adjusting Antenna Bearing
Move the Joystick right or left to adjust the azimuth position of the antenna right
or left. Monitor the displayed bearing value in the BEARING field.
When scanning horizontally, a Bearing Line may be displayed to aid in positioning
the antenna for the vertical scan. If the Bearing Line is not displayed, perform the
following steps:
1) Press the MENU Key
2) Turn the large FMS Knob to select 'Show Bearing Line'.
3) Press the ENT Key.
Vertically Scan a Storm Cell
1) While in the Horizontal Scan view, move the Joystick to place the Bearing
Line on the desired storm cell, or other area, to be vertically scanned.
2) Select the VERTICAL Softkey. A vertical 'slice' of the selected area will now
be displayed.
190-01344-00 Rev. B Garmin G1000 Cockpit Reference Guide for the Beechcraft 300/B300 Series
Hazard Avoidance
57