Activate An Arrival Leg; Load And/Or Activate An Approach Procedure - Garmin G1000 Reference Manual

Procedures
5) Press the ENT Key. A list of transitions is displayed for the selected arrival.
6) Turn either FMS Knob to select the desired transition.
7) Press the ENT Key. A list of runways is displayed for the selected arrival.
8) Turn the large FMS Knob to highlight the desired runway.
9) Press the ENT Key.
10) With 'LOAD?' highlighted, press the ENT Key.
11) The arrival will become part of the active flight plan.

ACTIVATE AN ARRIVAL LEG

1) Press the FPL Key on the Control Unit to display the active flight plan.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the TO waypoint of the desired leg
within the arrival.
4) Select the ACT LEG Softkey. A confirmation window showing the selected
leg is displayed.
5) With 'ACTIVATE' highlighted, press the ENT Key.

LOAD AND/OR ACTIVATE AN APPROACH PROCEDURE

NOTE: If certain GPS parameters (SBAS, RAIM, etc.) are not available, some
published approach procedures for the desired airport may not be displayed
in the list of available approaches.
1) Press the PROC Key.
2) Turn the large FMS Knob to highlight 'SELECT APPROACH'.
3) Press the ENT Key. A list of available approaches for the destination airport
is displayed.
4) Turn either FMS Knob to highlight the desired approach.
5) Press the ENT Key. A list of available transitions for the selected approach
procedure is now displayed.
6) Turn either FMS Knob to select the desired transition. The "Vectors"
option assumes vectors will be received to the final course segment of
the approach and will provide navigation guidance relative to the final
approach course.
32
Garmin G1000 Cockpit Reference Guide for the Beechcraft 300/B300 Series
190-01344-00 Rev. B