Important Safety Information - Mira Vision Installation Manual

IMPORTANT SAFETY INFORMATION

Installation must be carried out in accordance with these instructions and by
designated, qualified and competent personnel.
Warning!
Follow all warnings, cautions and instructions contained in this guide, and
on or inside the appliance.
1. THIS APPLIANCE MUST BE EARTHED. ENSURE SUPPLEMENTARY
BONDING COMPLIES WITH THE "REQUIREMENTS FOR ELECTRICAL
INSTALLATIONS".
The Mira Digital Mixer Valve is intended to be permanently connected to the
fixed electrical wiring of the mains system. A means for electrical isolation of the
appliance shall be provided in the fixed wiring in accordance with local wiring
regulations.
2. Products manufactured by us are safe and risk-free, provided that they are
installed, used and maintained in good working order, in accordance with our
instructions and recommendations.
3. Isolate the electrical and water supplies before connecting to the appliance.
4. Mains connections are exposed when the cover of the Digital Mixer Valve is
removed.
5. The Digital Mixer Valve must not be installed where it can become frozen
6. Make sure that any pipework that could become frozen is properly insulated.
7. A 30mA Residual Current Device (RCD) MUST be included in the electrical
circuit. This may be part of the consumer unit or a separate unit.
8. All pipework must be checked for leaks before the product installation is
completed. The product should be pressurised and both inlet & outlet connections
inspected.
9. Having completed the installation, make sure that the user is familiar with the
operation of the appliance.
10. Make sure that this guide is left with the user.
11. DO NOT commission this appliance if water leaks from the unit.
12. Only Mira recommended outlet fittings should be used.
13. Ensure all electrical connections are tight, to prevent overheating.
14. This product is not suitable for areas with high humidity (i.e steam rooms).
Please consult your installer.
15. The water supplies to this product must be isolated if the product is not to be
used for a long period of time. If the product or pipework is at risk of freezing
during this period they should also be drained of water.
4