Important Safety Information - Mira Elite ST Installation And User Manual

important safety information

1. warning!
1.1 Products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
1.2 This aPPliance musT be earTheD. maKe sure suPPlemenTarY
bonDinG comPlies wiTh The "reQuiremenTs for elecTrical
insTallaTions".
In accordance with the current edition of BS 7671 'the Iee wiring regulations'
in force at the time of installation. this appliance is intended to be permanently
connected to the fixed electrical wiring of the mains system with its own dedicated
supply.
1.3 Do noT twist the individual cable cores of the live and neutral conductors, as
this will prevent them from entering the terminal block.
1.4 the shower unit must noT be fitted where it may be exposed to freezing
conditions. Make sure that any pipework that could become frozen is properly
insulated.
1.5 Do noT operate this appliance if it appears to be frozen. Allow the appliance
to thaw and then contact your installer before using again.
1.6 there are no user serviceable components beneath the cover of this appliance.
only a competent tradesperson should remove the cover. If the cover is removed,
the following warnings must be observed:
1.6.1
turn off the electrical and water supplies before removing the cover.
1.6.2
mains connections are exposed when the cover is removed.
1.6.3
refer to the wiring diagram before making any electrical connections
(see section "wiring diagram").
1.6.4 make sure all electrical connections are tight, to prevent them
overheating.
1.7 If any of the following conditions occur, isolate the electricity and water supplies.
contact your installer or refer to "To contact us", on the back page of this
guide:
1.7.1
If water is leaking from inside the product.
1.7.2
If the case is damaged.
1.7.3
If the appliance begins to make an odd noise, smell or smoke.
1.7.4
If the appliance shows signs of a distinct change in performance,
indicating a need for maintenance.
1.7.5 If the cover is not correctly fitted.
1.8 Do noT fit any form of outlet flow control as the outlet acts as a vent for the
tank body. Only Mira recommended outlet fittings should be used.