Mira Vision Installation Manual page 19

The following procedure details how to assign the Wireless Controller to the Digital
Mixer Valve and test the remote signal strength.
Note! No plumbing connections are required for this test.
Note! Other radio signals from sources such as mobile phones, radio controlled
boiler thermostats, wireless broadband etc. can dramatically reduce the ability of
the Digital Mixer Valve to register.
It is recommended that such items are switched off during this process.
Place the Digital Mixer Valve in the required location, no more than 10 m from
the final position of the Wireless Controller.
Connect the Digital Mixer Valve to the electrical supply via a 3 amp fused
spur switch. Do not switch Digital Mixer on!
Bring Wireless Controller to within approximately 1 m of the
Digital Mixer Valve. Fit 3 x AA batteries supplied.
The wireless controller display will indicate the software version for 5 seconds
before displaying the clock default time of '4:00'.
Switch on the electrical supply to the Digital Mixer Valve.
The Wireless Controller will make 6 short beeps and the clock will change to
'10:00' as it registers itself to the Digital Mixer Valve. During this 30 second
process, a water droplet symbol will also appear on the screen.
Note! DO NOT remove the batteries or switch off the Digital Mixer Valve until
the droplet symbol disappears – this will indicate that the Digital Mixer Valve
and the Wireless Controller have been assigned to each other.
19