Table of Contents
Advertisement
Section
1
2
1. Warning!
1.1.
Products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
1.2.
THIS APPLIANCE MUST BE EARTHED. ENSURE SUPPLEMENTARY
BONDING COMPLIES WITH THE "REQUIREMENTS FOR ELECTRICAL
INSTALLATIONS".
In accordance with the current edition of 'The Plugs and Sockets etc. (Safety)
Regulations' in force at the time of installation, the Mira Extreme is intended
to be permanently connected to the fixed electrical wiring of the mains system.
1.3.
DO NOT connect the Mira Extreme to a mains-fed water supply. Such a
connection will damage the Mira Extreme, and is not covered under the
manufacturer's guarantee.
1.4.
The Mira Extreme must not be fitted where it may be exposed to freezing
conditions. Make sure that any pipework that could become frozen is properly
insulated.
1.5.
DO NOT operate the Mira Extreme if it is frozen. Allow the Mira Extreme to
thaw before using again.
1.6.
DO NOT operate the Mira Extreme if water leaks from the unit, maintenance
will be required before the Mira Extreme can be safely used.
1.7.
DO NOT allow the Mira Extreme to be run dry.
1.8.
DO NOT fit any form of outlet flow control. Only Mira recommended outlet
fittings should be used.
1.9.
There are no user serviceable components beneath the cover of the Mira
Extreme. Only a competent tradesperson should remove the cover.
1.10. If any of the following conditions occur, isolate the electricity and water
supplies and refer to "To contact us" on the back page of this guide.
1.10.1. If the cover is not correctly fitted and water has entered the case.
1.10.2. If the case is damaged.
1.10.3. If the Mira Extreme begins to make an odd noise, smell or smoke.
1.10.4. If the Mira Extreme shows signs of a distinct change in
performance,indicating a need for maintenance.
1.10.5. If the Mira Extreme is frozen.
1.11. Turn off the electrical and water supplies before removing the cover. The
electricity must be turned off at the mains and, if applicable, the appropriate
circuit fuse removed.
1.12. Mains connections are exposed when the cover is removed.
4
Important Safety Information
Advertisement
Table of Contents
