Siemens SINAMICS S120 Series Function Manual page 199

No.
6
10
11
Communication
Function Manual, 12/2018, 6SL3097-5BD00-0BP0
Service Type Name
get_and_
UINT32 Alignment Errors
clear
UINT32 FCS Errors
UINT32 Single Collisions
UINT32 Multiple Colli-
sions
UINT32 SQE Test Errors
UINT32 Deferred Trans-
missions
UINT32 Late Collisions
UINT32 Excessive Colli-
sions
UINT32 MAC Transmit
Errors
UINT32 Carrier Sense
Errors
UINT32 Frame Too Long
UINT32 MAC Receive
Errors
get, set Struct of Interface Control
UINT16 Control Bits
UINT16 Forced Interface
Speed
get String Interface_Label
get - Interface Capabil-
ity
Communication via Ethernet/IP (EIP)
Value/explanation
Structure received, which does not match the num-
ber of octets
Structure received, which does not pass the FCS
check
Structure successfully transmitted, precisely one
collision
Structure successfully transmitted, several colli-
sions
Number of SQE errors
First transmission attempt delayed
Number of collisions that occurred delayed by 512
bit timers to the request
Transmission unsuccessful as a result of intensive
collisions
Transmission unsuccessful as a result of an internal
MAC sublayer transmission error.
Number of errors when attempting to send a re-
quest frame, where the transmission condition was
lost or was not assigned
Structure too large
Transmission unsuccessful as a result of an internal
MAC sublayer receive error.
-
-
-
Interface-Label
Bit 0: Manual Setting
Bit 1: Auto-negotiate
Bit 2: Auto-MDIX
Bit 3: Manual Speed/Duplex
Bit 4 - 31: reserved
Remaining: Speed/Duplex Options
7.6 Supported objects
197