Spacer Installation - Regency Liberty LRI4E series Owners & Installation Manual

SPACER INSTALLATION

1. Remove Vignette faceplate from unit and lay on a soft surface.
2. Remove the outer faceplate by removing the 5 screws as shown.
Note: the two top and two bottom screws can be loosened - slide the
outer faceplate up on out to remove.
3. Separate the Outer Faceplate from the Backing Plate by removing
7 screws.
SPACER INSTALLATION
4. Place the spacer on a soft cloth on the floor. Lay the outer faceplate
over the spacer and line up the 7 holes. Attach the 3 piece spacer to
the back of the outer faceplate from the front with 7 screws (3 along
the top and 2 on each side).
tooltip
5. Reinstall the outer faceplate and spacer—reverse Step 2.
6. Reinstall the Vignette faceplate and safety screen to complete.
installation
LRI4E / HRI4E-11 Direct Vent Gas Insert
4E/6E
| 45