Regency Liberty LRI4E series Owners & Installation Manual page 34

HRI6E / HRI4E
installation
3. Place Log 1 on Rear Log Bracket in front of tabs, ensure Log is
centered.
Pilot area needs to be clear to allow for proper ignition.
Center Log 1 on bracket
4. Place Log 2 on the glass, angled with the non charred point of the Log
is approximately 9-1/4" from the right side of the burner tray.
34 |
LRI4E / HRI4E-11 Direct Vent Gas Insert
919-350b
1
1
2
2
9-1/4"
Position Log 2
5. Place Log 3, rest on Log 2, match pin locator on Log 3 with landing
pin on Log 1. Angle the longest point on Log 3 is approximately 1/4'
from the outside edge of the burner tray.
1
Line up pin locator and pin, Logs 1,3
6. Place Log 4, match pin locator on Log 4 with landing pin on Log 1.
Angle the longest point on Log 4 is approximately 1/4' from the out-
side edge of the burner tray.
4
Line up pin locator and pin, Logs 1,4
7. Place Log 5 across Log 4,match pin locator on Log 5 with landing
pin on Log 4.
Note: there are 2 pin locators on Log 5, lower locator is f o r HRI4E units
and the upper locator is for the HRI6E units.
5
Line up pin locator and pin, Logs 5,4
2
3
2
1
3
2
1
HRI6E Pin Landing
HRI4E Pin Landing
4
07.18.16