installation
OPTIONAL WALL THERMOSTAT INSTALLATION
This installation must be completed during intial install prior to the faceplate being installed.
A wall thermostat may be installed if desired.
1) Run wires from thermostat into the unit.
2) Remove the green wire marked (TH) at the white connector-shown below. The noted wires will be located near the gas valve.
Green Wires
Disconnect greenTH wire
3) Connect one thermostat lead to female connector, using male spade con-
nector - see picture below.
28
|
LRI4E / HRI4E-11 Direct Vent Gas Insert
White Connector
CAUTION
Do not wire
Thermostat wires
to 120V wire.
4) Connect the other thermostat lead to male connector disconnected
from Step1using a female spade connector - see picture below.
When complete turn remote receiver to the ON position.
Unit will now operate using the wall thermostat.
NOTE: When the remote receiver is set to ON position, the
remote control transmitter and all of its features are now dis-
abled.