Optional Wall Thermostat Installation - Regency PANORAMA P33E Owners & Installation Manual

Hide thumbs Also See for PANORAMA P33E:
Table of Contents

Advertisement

OPTIONAL WALL THERMOSTAT INSTALLATION

A wall thermostat may be installed if desired.
Recommended: The Wall Thermostat should be mounted beside the Remote/Unit Receiver which comes standard with the appliance.
1) Run wires from thermostat into the unit.
2) Remove the green wire marked (TH) at the white connector-shown below. The noted wires will be located near the gas valve.
Green Wires
Disconnect greenTH wire
3) Connect one thermostat lead to female connector, using male spade con-
nector - see picture below.
White Connector
CAUTION
Do not wire
Thermostat wires
to 120V wire.
4) Connect the other thermostat lead to male connector disconnected
from Step1using a female spade connector - see picture below.
When complete turn remote receiver to the ON position.
Unit will now operate using the wall thermostat.
NOTE: When the remote receiver is set to ON position, the
remote control transmitter and all of its features are now dis-
abled.
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
installation
|
43
|
43

Advertisement

Table of Contents
loading

Table of Contents