Table of Contents
Advertisement
C2000 and C4000 1.0.x Hardware Guide
2.
3.
To install a power supply module:
1.
2.
Figure 11: C2000 Power Supply
Figure 12: C4000 Power Supply
Removing and Installing a Hard Drive
NOTE: If your system is powered on, see the SRC PE Getting Started User Guide for
commands to run before performing these steps.
To remove a hard drive:
1.
2.
To install a hard drive, hold the locking tab to the right and slowly slide the unit into
the chassis until it clicks into place.
34
Removing and Installing a Hard Drive
Slide the locking tab (ejector button) to the left to release the module. See
Figure 11
and
Figure 12
.
Hold the tab to the left, and using the handle, slowly pull the power supply module
out.
Hold the locking tab (ejector button) to the left, and slowly slide the module into
the chassis until it clicks into place.
Insert the power cord into the AC power IEC receptacle.
Slide the locking tab in the bottom-right corner to the right to release the hard
drive.
Hold the tab to the right and slowly pull the unit out.
Advertisement
Table of Contents
