Installation Guidelines; Preparing The Equipment Racks; Installing The System - Juniper C2000 Hardware Manual

Hide thumbs Also See for C2000:
Table of Contents

Advertisement

C2000 and C4000 1.0.x Hardware Guide
system with easy access to the connections that it needs for power, local
communications, and remote communications.
WARNING: Two people are required to lift the system.
CAUTION: To prevent electrostatic damage to the system and its components, make
sure persons handling the system wear an antistatic device.
Rack-Mounted Installation
We recommend that you use a standard EIA distribution rack. See
Requirements"

Installation Guidelines

Before installing the systems in a rack, consider the following guidelines:

Preparing the Equipment Racks

Following your installation plan, use a tape measure and marking pen to measure
and mark space on each equipment rack for each system component. For horizontal
spacing follow Network Equipment Building System (NEBS) requirements.

Installing the System

To complete the installation of the system in a rack, you need:
To install the system in the rack:
14
Rack-Mounted Installation
on page 46 for rack information.
You can install several models in a single 7-ft. (2.1-m) rack. Installing multiple
systems in a single rack enables you to maximize your available space.
Install heavier systems on the bottom of the rack. Mount lighter systems higher
in the rack.
A Phillips screwdriver
Eight 10-32 x 3/8 Phillips screws (provided) for each model to be installed
"Equipment Rack

Advertisement

Table of Contents
loading

This manual is also suitable for:

C4000C series

Table of Contents