Mounting The Transponder; Electrical Installation - Siemens SIMATIC HMI Operating Instructions Manual

Result
The batteries have been inserted in the transponder. The transponder ID is now set.
See also
Distance measurement between HMI device and transponder (Page 61)
4.4

Mounting the transponder

Requirements
● 2 x M4 cylinder head screws, with nuts if required
● The batteries have been fitted in the transponder and the ID is set
● You have selected a position that provides good illumination for the desired area
Procedure
Proceed as follows:
1. Place the transponder from the front onto the mounting surface.
2. Mark the fastening holes with a marking-off tool.
3. Drill two through holes or two threaded holes M4.
4. Attach the transponder.
Result
The transponder is now mounted.
4.5

Electrical installation

Electrical connections
The following connection options are available:
Configuring PC
Supply voltage
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
The transmitting range of the transponder and the receiving area of the HMI device
approximate to a lobe shape with a range of approximately 8 m. More information can be
found in chapter Radiation characteristic (Page 314) .
HMI device Charging station
Yes
Installation and connection
4.4 Mounting the transponder
Tabletop power supply
Yes
unit
Yes
69