Siemens SIMATIC HMI Operating Instructions Manual page 133

1. If necessary, select the encryption you are using under "Encryption".
2. If necessary, select the required authentication process under "Authentification".
3. If necessary, enter the password for the WLAN network under "Network key".
4. If necessary, select the type of authentication protocol under "EAP type".
5. Confirm your entries.
Procedure for parameterizing list of preferred networks
1. In the "WLAN" dialog box, "Wireless" tab, press Advanced... to open the "Advanced
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
Note
If the HMI device has detected the WLAN network, the encryption and the authentication
process for this network will already be shown in the dialog box.
If necessary, you must also enter the appropriate password in the "Network key" text box.
After you have entered the password, it is shown in encrypted form.
The dialog closes. The parameterized WLAN network is added to the list of preferred
networks.
If the HMI device is connected to the WLAN network, the WLAN network is put at the top
of the list of preferred networks.
Wireless Settings" dialog box.
Configuring the operating system
6.2 WLAN
133