Activating Vibration Alarm - Siemens SIMATIC HMI Operating Instructions Manual

Procedure for displaying memory information
NOTICE
"Memory" tab
Do not change the memory distribution in the "Memory" tab.
Only applies for the usage of options:
An alteration to the memory distribution may be necessary. Please refer to the
accompanying documentation for the option for additional information.
Proceed as follows:
1. Change to the "Memory" tab.
1. Close the dialog.
6.6.10

Activating vibration alarm

Introduction
You can activate a vibration alarm for the HMI device. The vibration alarm will be triggered in
the current project under the following circumstances:
● You leave the effective range with the HMI device without logging the HMI device off from
● The charging status of the main battery is critical.
Requirements
You have opened the "OP Properties" dialog box, "Vibration Alarm" tab, by touching the
"OP"
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
The memory information is displayed.
the effective range.
icon.
Configuring the operating system
6.6 Changing HMI device settings
159