Stp Port And Trunk Configuration - SMC Networks TigerSwitch 100 Management Manual

C
ONFIGURING THE
CLI – This example displys the current Spanning Tree status of a port.
Console#show spanning-tree ethernet 1/5
Eth 1/ 5 information
--------------------------------------------------------------
Admin status
Role
State
Path cost
Priority
Designated cost
Designated port
Designated root
Designated bridge
Fast forwarding
Forward transitions
Admin edge port
Oper edge port
Admin Link type
Oper Link type
Console#

STP Port and Trunk Configuration

You can configure RSTP attributes for specific interfaces, including port
priority, path cost, link type, and edge port. You may use a different
priority or path cost for ports of same media type to indicate the preferred
path, link type to indicate a point-to-point connection or shared-media
connection, and edge port to indicate if the attached device can support
fast forwarding. (References to "ports" in this section means "interfaces,"
which includes both ports and trunks.)
Command Attributes
• STP State — Displays current state of this port within the Spanning
Tree:
- Discarding — Port receives STP configuration messages, but does
not forward packets.
- Learning — Port has transmitted configuration messages for an
interval set by the Forward Delay parameter without receiving
contradictory information. Port address table is cleared, and the port
2-58
S
WITCH
: enable
: designate
: forwarding
: 100000
: 128
: 0
: 128.5
: 32768.000011112222
: 32768.000011112222
: disable
: 1
: disable
: disable
: auto
: point-to-point
3-119