SMC Networks TigerSwitch 100 Management Manual page 106

C
ONFIGURING THE
- 1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port transmits
tagged frames that identify the source VLAN. However, note that
frames belonging to the port's default VLAN (i.e., associated with the
PVID) are sent untagged.
- Hybrid – Specifies a hybrid VLAN interface. The port may receive
or transmit tagged or untagged frames.
• Trunk Member – Indicates if a port is a member of a trunk. To add a
trunk to the selected VLAN, use the last table on the VLAN Static
Table page.
Web – Click VLAN, VLAN Port Configuration or VLAN Trunk
Configuration. Fill in the required settings for each interface, click Apply.
CLI – This example sets port 1 to accept only tagged frames, assigns
PVID 3 as the native VLAN ID, enables GVRP, sets the GARP timers,
and then sets the switchport mode to hybrid.
2-76
S
WITCH