SMC Networks TigerSwitch 100 Management Manual page 52

C
ONFIGURING THE
CLI Commands
CLI – Enter the following commands to configure the SSH service.
Console(config)#ip ssh server
Console(config)#ip ssh timeout 100
Console(config)#ip ssh authentication-retries 5
Console(config)#
Console#show ip ssh
Information of secure shell
SSH status: enable
SSH authentication timeout: 100
SSH authentication retries: 5
Console#show ssh
Information of secure shell
Session Username Version Encrypt method Negotiation state
------- -------- ------- -------------- -----------------
0
Console#disconnect ssh 0
Console#
Managing Firmware
You can upload/download firmware to or from a TFTP server. By saving
runtime code to a file on a TFTP server, that file can later be downloaded
to the switch to restore operation. You can also set the switch to use new
firmware without overwriting the previous version.
Command Attributes
• TFTP Server IP Address – The IP address of a TFTP server.
2-22
S
WITCH
admin 1.5 cipher-3des session-started
3-35
3-34
3-34
3-37
3-37
3-36