Port Trunk Configuration - SMC Networks 8624T - annexe 1 Management Manual

C
ONFIGURING THE

Port Trunk Configuration

Ports can be combined into an aggregate link to increase the bandwidth of
a network connection where bottlenecks exist or to ensure fault recovery.
You can create up to six trunks at a time, with any single trunk containing
up to four ports.
The switch supports both static trunking and dynamic LACP (Link
Aggregation Control Protocol). LACP configured ports can automatically
negotiate a trunked link with LACP-configured ports on another device.
You can enable LACP on any port that is not already a member of a static
trunk. If LACP is also enabled for the connected ports on another device,
the switch and the other device will automatically create a trunked link.
Besides balancing the load across each port in the trunk, the other ports
provide redundancy by taking over the load if a port in the trunk fails.
However, before making any physical connections between devices, use
the Web interface or CLI to specify the trunk on the devices at both ends.
When using a port trunk, take note of the following points:
• Finish configuring port trunks before you connect the corresponding
network cables between switches to avoid creating a loop.
• The ports at both ends of a connection must be configured as trunk
ports.
• The ports at both ends of a trunk must be configured in an identical
manner, including communication mode (i.e., speed, duplex mode and
flow control), VLAN assignments, and CoS settings.
• All ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.
• All the ports in a trunk have to be treated as a whole when moved
from/to, added or deleted from a VLAN.
• STP, VLAN, and IGMP settings can only be made for the entire trunk.
2-64
S
WITCH