Ssh; Cli Commands - SMC Networks TigerSwitch 100 Management Manual

CLI Commands

CLI – Enter the following commands to specify the secure port number
and to enable HTTPS.
Console(config)#ip http secure-server
Console(config)#ip http secure-port 441
Console(config)#

SSH

The Secure Shell (SSH) server feature provides remote management access
via encrypted paths between the switch and SSH-enabled management
station clients.
Note: There are two versions of the SSH protocol currently available,
SSH v1.x and SSH v2.x. The switch supports only SSH v1.5.
Command Attributes
• SSH Server Status — Allows you to enable/disable the SSH server
feature on the switch. (Default: enabled)
• SSH authentication timeout — Specifies the time interval in seconds
that the SSH server waits for a response from a client during an
authentication attempt. (Range: 1 to 120 seconds; Default:
120 seconds)
• SSH authentication retries — Specifies the number of
authentication attempts that a client is allowed before authentication
fails and the client has to restart the authentication process.
(Range: 1 to 5 times; Default: 3)
Web – Click System, SSH Settings. Select "Enabled" for the SSH Server
Status, specify the authentication timeout and number of retries, then click
Apply.
S
ECURITY
3-32
3-33
2-21