Changing The Paper Size; Precautions For Changing The Paper Size; Changing The Paper Size In Trays 1, 2, And The Wide Large Capacity Tray - Ricoh Pro C9200 Operator's Manual

Changing the Paper Size

Precautions for Changing the Paper Size

• When loading paper, take care not to trap or injure your fingers.
• Do not stack paper over the limit mark.
• Do not change the size of the paper for the specified printing tray while documents are being
printed.
• After loading paper whose sizes are not detected automatically, be sure to specify the appropriate
paper size in [Tray Paper Settings]. If you do not, misfeeds might occur. For details, see page 116
"Changing to a Size That Is Not Automatically Detected".
• To prevent multiple sheets from being fed at once, fan the paper before loading.
• Straighten curled or warped paper before loading.
• For details about the paper sizes and types that can be used, see page 119 "Recommended
Paper Sizes and Types".

Changing the Paper Size in Trays 1, 2, and the Wide Large Capacity Tray

The paper size setting is changed in the same way for each paper tray.
• Check that the paper edges are aligned with the left side.
• Pay attention to the following things when using the banner sheet tray of wide LCT:
• Set one long-end fence between the paper size indicators under the bottom plate. If you set
the end fence on the bottom plate, the end fence may collide with the upper part of the paper
tray and fall over inside the machine. Contact your sales representative if the end fence falls
over inside the machine.
• Set the two short-end fences to the right and left of the paper size indicators on the bottom
plate.
• If you are not using the end fences, push them down and keep them to the side in the paper
tray. If you keep the end fences in any other position, they may fall over inside the machine, or
the end fences may interfere while you load paper.
Changing the Paper Size
109