Ricoh Pro C9200 Operator's Manual page 274

8. Maintenance
• Replace the waste toner bottle if "Waste Toner Bottle is full. Replace Waste Toner Bottle." appears
on the control panel.
• When the "Replacement of Waste Toner Bottle will soon be necessary." appears on the control
panel, the waste toner bottle should be replaced soon. Prepare a new waste toner bottle.
• Your service representative can replace the waste toner bottle if it is included in your contract. For
details, contact your local dealer or service representative.
Adding Staples
• Keep your hands clear of the booklet finisher tray when removing misfed paper, pulling out or
pushing in the finisher's staple unit. You can trap and injure your fingers if you do not.
• Stapling failures or jams may occur if you use a staple cartridge other than that recommended.
Follow the instruction on the control panel regarding how to add staples.
• If you cannot pull out the upper unit, there are staples remaining inside the cartridge. Use all the
staples, and do not add more.
Replacing Ring Combs
• Keep your hands clear of the inside of the ring binder and the space under the ring binder tray.
You can trap your fingers if you do not.
• Use of non-recommended ring combs and/or ring comb cartridges can result in binding failures
and comb jams.
Follow the instruction on the control panel regarding how to replace ring combs.
• Add new ring combs to the cartridge only when the "Out of binding ring combs" message appears
on the control panel.
• The ring comb cartridge can hold both 100-sheet and 50-sheet type ring combs, but be sure not to
mix the two sizes inside the cartridge.
272