Ricoh Pro C9200 Operator's Manual page 246

7. Troubleshooting
• Multiple paper misfeed locations may be indicated at the same time. When this happens, check all
the areas indicated.
• If there is no misfed paper in the area you check first, see the other areas that are indicated.
• If coated paper frequently becomes jammed and causes "U" to appear, contact your service
representative.
• If a paper misfeed occurs in Rb1 – Rb5, check whether any paper has been output on top of the
paper press of the finisher shift tray. If there is paper on top of the paper press, remove the paper,
and then remove the misfed paper from inside the finisher.
Procedure for removing jammed paper
1. Remove the jammed paper by following the procedures that are displayed on the control
panel.
When [Previous] or [Next] is displayed, press [Next] after completing a procedure.
2. When the jammed paper is removed, restore the machine to the original state.
• When you pull out and push back the right paper tray, make sure that B2 and B3 guide plates are
closed. If you pull out and push back the right drawer unit while B2 and B3 guide plates are open,
the right paper tray may hit the guide plates, which could result in damage to the machine.
244
DWQ505