Ricoh Pro C9200 Operator's Manual page 164

6. Adjustment Settings for Operators
No.
0507 Screw-on Cap to Replace
0508 Execute Developer
Refreshing
0509 Execute Photoconductor
Refreshing
0510 Execute Charger Unit
Cleaning
0512 Fusing Belt Smoothing
Setting
0513 Smooth Fusing Belt
0516 Manage Multiple Fusing
Units by Counter
Finishing: Finisher
For details about the following items, see page 184 "Finishing: Finisher".
No.
0601 Staple Position: Across
Feed 1
0602 Staple Position: Across
Feed 2
0603 Staple Position: With Feed
0604 Paper Alignment for
Stapling: Across Feed
162
Item
Close the Toner Bottle Cap.
Open the toner bottle cover (the cover of the toner
dispensing section) before executing this function.
Afterward, remove the toner bottle by pushing the knob
below the bottle.
The machine uses degraded toner in the development
unit and adds new toner from the toner bottle.
Remove dust on the drum surface.
Cleans the Charge Unit.
Specify the condition to execute Fuser Belt smoothing.
Smooth the Fuser Belt to remove vertical and horizontal
lines from the printouts.
Display the counter of Fusing Unit parts.
Item
Adjust the vertical position of the staple (applied at an
edge) when using Finisher SR5050 or Booklet Finisher
SR5060.
Adjust the vertical position of the staples (dual) when
using Finisher SR5050 or Booklet Finisher SR5060.
Adjust the horizontal position of the staples when using
Finisher SR5050 or Booklet Finisher SR5060.
Adjust the width of the Staple Jogger
staple function on Finisher SR5050 or Booklet Finisher
SR5060.
Description
Description
*1
when using the