Ricoh Pro C9200 Operator's Manual page 247

• Do not leave the right drawer unit pulled out for a long time when removing paper from B or C.
Some parts may be deformed and require replacement if you leave the unit pulled out for more
than 10 hours.
• When you remove jammed paper from C3 and D3, the toner that was not fixed to the paper may
attach to the carrier belt and the area around it. If the toner is attached, dampen the cleaning cloth
that comes with the machine or similar cloth and wipe the toner off, and then wipe the area again
with a dry cloth.
Removing jammed paper when the procedure is not displayed on the control panel
If a paper jam has occurred in certain locations, the procedure for removing the jammed paper is not
displayed on the control panel. Open the front cover in the place corresponding to the letter displayed
(on the control panel), and then proceed as instructed on the sticker or sheet inside the front cover, or in
the following descriptions. If a lamp is lit when the front cover is opened, open the guide plate at the
indicated location, and remove the jammed paper.
DFL005
DFL006
Clearing Misfeeds
245