Siemens SIPROTEC 5 Operation Manual page 57

Operator Element/Display
Element
NOTE
i
i
Note that terminating the contacts of saved output indications can lead to reactions in the device environ-
ment.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
5.2 Overview of Operator Elements and Display Elements
Function
Control key for activating standard control display
If no control display is available (not configured or device with small
display), you are taken directly to the standard default display.
If it has not already been selected, and depending on device configuration,
pressing the <CTRL> key jumps directly to:
•
Large Display → Default display
•
Large display/at least one control display → Standardcontrol display
•
Small Display → Default display
Control key for switching on a selected switching object
Select the switching object either in the Control menu or in the control
display (only in devices with large display).
Control key for switching off a selected switching object
Select the switching object either in the Control menu or in the control
display (only in devices with large display).
USB ports
There are 2 USB ports with plastic cover available to you:
•
Top USB port (host)
Connection for a DIGSI PC
•
Bottom USB port
Reserved for the future applications
16 parameterizable LEDs
•
Dual-colored configurable (red and green)
Key for resetting saved displays and contacts
With this key you can reset stored information that is configured on the
LEDs, on the display or on output contacts. The initial state is then restored.
When the key is pressed, all LEDs are activated simultaneously, allowing
you to execute a test of the LEDs.
Using On-Site Operation Panel
57