Reading Indications From The Pc With Digsi 5 - Siemens SIPROTEC 5 Operation Manual

Operation in the Operating State
8.4 Indications
[scoprlog-090413-01.tif, 1, en_US]
Figure 8-6
Menu Path
Main menu → Indications →
Main menu → Test & Diagnosis → Indications →
To reach the desired log from the main menu, use the navigation keys of the on-site operation panel.
²
Navigate inside the log using the navigation keys (top/bottom). You will find the most current indication
²
at the top of the list. The selected indication is shown with a dark background.
Which indications can be shown in the selected log depends on the assignments in the DIGSI 5 informa-
²
tion routing matrix or is pre-defined. You will find information about this in chapter
Every indication contains date, time and its state as additional information.
²
In some logs you are given the option of deleting the entire indication list by softkey in the footer of the
²
display. To know more about this, read chapter
NOTE
i i
No password entry is necessary to read indications from the device.
8.4.3

Reading Indications from the PC with DIGSI 5

Procedure
Menu Path (Project)
Project → Device → Process data → Log →
114
On-Site Display of an Indication List (Example: Operational Indications)
Log
Operational log
Fault log
Ground-fault log
Setting changes
User indications 1
User indications 2
Security indications
Device diagnosis
Communication indications
8.4.6 Saving and Deleting the
Log
Operational log
Fault log
Ground-fault log
Setting changes
User indications 1
User indications 2
C53000-G5040-C003-7, Edition 06.2016
8.4.5.1 General.
Logs.
SIPROTEC 5, Operation, Manual