Receiver Installation - FUTABA T4PM Instruction Manual

Digital proportional r/c system for use with surface models
Table of Contents

Advertisement

Receiver Installation

NOTE: The R304SB, R334SBS and R334SBS-E receiver are operating range may reduced, depending on where the receiver
and the antenna are mounted.
NOTE: The R304SB, R334SBS and R334SBS-E receiver are put the antenna in the antenna tube to protect it. Do not let the tip
go outside.
NOTE: The R334SBS and R334SBS-E receiver of diversity type with both external and internal antennas. Do not place wiring or
other objects on the plate. The receiving range may be affected.
NOTE: An antenna is installed inside the R314SB-E receiver on the top. Do not place wiring or other objects on the plate. The re-
ceiving range may be affected.
Antenna
WARNING
Install the antenna in the higher place as shown in the figure.
Do not cut or bundle the receiver antenna wire.
Do not bend the coaxial cable. It causes damage.
Do not pull the receiver antenna or coaxial cable by force.
Keep the antenna as far away from the motor, ESC and other noise sources as you possibly can.
Wrap the receiver with something soft, such as foam rubber, to avoid vibration. If there is a chance of getting
wet, put the receiver in a waterproof bag or balloon.
Always use R334SBS under the following conditions:
Battery
:Power requirement Rated voltage 3.8 to 7.4V (dry cell battery cannot be used)
Matched to the ratings of the receiver and connected servo.
• Transmitter's receiver system > T-FHSS SR --- SR mode channel (ON):
• Transmitter's receiver system > T-FHSS SR --- SR mode channel (OFF): Normal mode of Futaba SR compatible servo.
• Transmitter's receiver system > T-FHSS/S-FHSS
Transmitter's response type: Digital servo: Futaba digital servo
Transmitter's response type: Analog servo: Futaba all servo (Normal mode of Futaba SR compatible servo.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In addition, it
may cause trouble with servos and other equipment. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
24
Cap
Antenna
tube
R334SBS-E
Antenna tube
Antenna
Coaxial cable
R334SBS
SR mode of Futaba SR compatible servo.
Futaba digital servo.
Antenna tube
Antenna
Coaxial cable
R304SB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents