FUTABA T4PM Instruction Manual page 32

The telemetry ON/OFF and communication status can be checked at the HOME screen.
- Telemetry function :ON
- Receiver ID setting complete
- Data receiving sensitivity display
- shows that data cannot be re-
ceived because it is outside the data re-
ceiving range or because of the effects
of an obstruction or the receiver power is
OFF after receiver ID check.
Receivers Other Than T-FHSS
1
Bring the transmitter and the receiver close to each other,
within 20 inches (half meter).
2
Turn on the transmitter.
3
Turn on the receiver.
4
Push the Link switch of the receiver.
When the link is complete, the LED in the receiver changes
to solid green.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Receiving signals, but ID is unmatched.
Unrecoverable failure (EEPROM,etc.)
32
The reception strength
High
Low
No signal reception
Receiver -> Transmitter:
The reception strength is shown.
- Telemetry function :ON
- Receiver ID before setting or ID mis-
match.
Telemetry function :OFF
Red : On
Green: On
*1
Green: Blink (T-FHSS ,Red : On)
LED: Red and Green turn on alternately