FUTABA T4PM Instruction Manual page 113

Using the Lap timer
(Preparation)
Select the setting item "TYPE" by moving the (JOG) button up
or down. Press the (+) or (-) button and select "LAP".
1
(Alarm time setting)
Select the setting item "ALRM" by moving the
(JOG) button up or down and set the alarm time
with the (+) and (-) buttons.
2
(Timer start/ lap count/ stop operation)
When the switch ("TIMER") set by function se-
lect switch function is pressed, the timer starts.
During operation, the same switch becomes the
lap switch and when the set time elapses, the
timer is stopped by the same switch.
- Linking only start to the throttle trigger
Select the setting item "RST" by moving the
(JOG) button up or down and press the (JOG)
button for approximately 1 second. When the
set beeps and the status display switches from
"RST" to blinking "RDY", the system enters the
trigger operation ready state. When the trigger
is operated at the forward side, the timer starts.
(Status display "RUN")
When the switch (TIMER) is pressed after the
time set by alarm has elapsed, the timer stops
and the lap time and total time are memorized.
The status display becomes "GOAL".
If the (END) button is pressed while the timer is operating, the
LCD returns to MENU screen.
3
(Timer reset operation)
Select a status display ("GOAL") using the (JOG)
button and press the (JOG) button for approxi-
mately 1 second. A beeping sound is generated
and "RST" appears on the status display and
the timer resets.
screen.
" set
"
Timer Function "TIMER"
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons si-
multaneously (approx. 1 sec).
Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 5 m
Switches
Timer start / Lap count
Status display
RST: Reset state
RDY: Throttle trigger operation wait
RUN: Timer running
GOAL: Timer stopped
Operation wait
: Press the (JOG) button
TRG: Throttle trigger operation
Status display
RST: Reset state
RDY: Throttle trigger operation wait
RUN: Timer running
GOAL: Timer stopped
113