FUTABA T4PM Instruction Manual page 33

Kyosho Mini-Z EVO dedicated receiver RA-42
1
Bring the transmitter and the receiver close to each other, within 20 inches (half meter). Turn
on the receiver.
2
Turn on the transmitter.
3
Turn on the Mini-Z receiver RA-42.
4
Press the T4PM transmitter's (JOG) button up or down to move the cursor to "LINK: EXE".
When the (JOG) button is pressed for approximately 1 second, "PUSH RX LINK SW" ap-
pears on the screen and a 20 second countdown begins. Countdown can be canceled at
any time pressing the (JOG) button up, down or left, right.
5
Push the receiver side push switch for about 2 seconds or more and release the Link SW.
LED 2 seconds solid
Touch the [END] button on the link screen of the transmitter to cancel the link mode.
6
Completed with LED solid the receiver.
Warning
After the linking is done, please cycle receiver power and check if the receiver to be linked is really under the
control of your transmitter.
If there are many Futaba 2.4GHz systems (T-FHSS SR / T-FHSS / S-FHSS / MINIZ) turned on in close proximity to your receiv-
er might not link to your transmitter. In this case, even if the receiver's LED stays solid green, unfortunately the receiver might
have established a link to one of other transmitters. This is very dangerous if you do not notice this situation. In order to avoid
the problem, we strongly recommend you to double-check whether your receiver is really under control by your transmitter by
giving the stick input and then checking the servo response.
Do not perform the linking procedure with motor's main wire connected or the engine operating as it may re-
sult in serious injury.
Blink
Push switch
LED
33