Omron SYSMAC CS Series Operation Manual page 298

How to Use the Sequence Table Block
Actions
The following contact signals can be used for sequence table outputs.
Signal Notation on CX-
Process Tool
screen
Output OUT_H (destina-
tion): Holding contact
(See note.)
output operation
OUT_L (destina-
tion): Non-holding
contact output oper-
ation
OUT_P (destination):
Pulse contact output
operation
OUT_F (destina-
tion): Flashing con-
tact output operation
Table Com- STEP(sequence
mand table block address,
step number)
RUN(sequence table
block address)
STOP(sequence
table block address)
Write to SET(value, destina-
ITEM tion)
266
Types Settings on CX-Process
Function block Output tab destination
contact output specification: Block ITEM
item
CSV tag and tag Output tab destination
ITEM specification: Tag No.
(Contact output
ITEM for control
and operation
blocks)
User link table Output tab destination
name (I/O mem- specification: User link
ory in CPU Unit) table
Timer/counter Output tab destination
reset start, opera- specification: Element
tion start/stop, action (destination)
and pause com-
mands
Setting of a spe- Table Command Tab com-
cific step in mand classification:
another sequence STEP(block address, step
table number)
Starting another Table Command Tab com-
sequence table mand classification:
RUN(block address)
Stopping another Table Command Tab com-
sequence table mand classification:
STOP(block address)
Writing a con- Write to ITEM tab destina-
stant to a function tion: Block ITEM
block ITEM write
parameter
Writing a con- Write to ITEM tab destina-
stant to an CSV tion: Tag No.
tag and tag ITEM
(Contact output
ITEM for control
and operation
blocks)
User link table Write to ITEM tab destina-
(writing a constant tion: User link table
to I/O memory in
the CPU Unit)
Setting method
Tool screen
Select the block ITEM
and select the ITEM
number from the
detailed information.
Select the ITEM tag
and select the tag
ITEM from the detailed
information.
Select the block ITEM
and select the ITEM
number from the
detailed information.
Select the area type
and select the link
table tag name from
the detailed informa-
tion.
Block address and
step number
Block address
Block address
Select the block ITEM,
select the ITEM num-
ber from the detailed
information, and input
the write data (-32,000
to 32,000).
Select the ITEM tag,
select the tag ITEM
from the detailed infor-
mation, and input the
write data (-32,000 to
32,000).
Select the area type,
select the user link
table tag from the
detailed information,
and input the write
data (-32,000 to
32,000: Input the
scaled value for the
user link table).
Appendix B
Example
For block
address 001
and ITEM
086: 001.086
For the A/M
switch for the
Master01
CSV tag:
Master01.A_
M
For Value1
user link
table tag:
LNK007:Valu
e01
---
For block
address 702,
step 03:
70203
For block
address 702:
702
For block
address 702:
702
---
---
---