Denso GT10Q-SB User Manual page 57

2d code handy scanner

Table of Contents

(Note 1) Type 2 is a code ID mark system compliant with the AIM USA "Guidelines on Symbology Identifiers." The m"

suffix is a modifier character that differs depending upon options of individual symbologies as defined below.

Code Type

QR Code

codes

MaxiCode

Data

Matrix

Interleaved

Bar

2of5

codes

Code 39

Codabar

Code 128

Example: The code ID mark for Interleaved 2of5 with option "Scanning enabled, with a check digit (Check digit

transmission disabled)" is ]I3.

]: Flag character (ASCII 93h)

I: Code character (Interleaved 2of5)

3: Modifier character (See the table above.)

(Note 2) For code ID marks not compliant with the AIM USA "Guidelines on Symbology Identifiers," the same characters

as ones defined in Type 1 apply.

(Note 3) These code ID marks are contained in code data.

(Note 4) RSS represents: RSS-14, RSS-14 Truncated, RSS-14 Limited, RSS-14 Stacked, RSS Expanded, RSS-14 Stacked

Omnidirectional, and RSS Expanded Stacked.

"m"

(Modifier

character)

Model 1

Model 2

Model 2, ECI protocol not implemented, FNC1 implied in first position

mode 4, mode 5

mode 2, mode 3

ECC-200

ECC-200 (FNC1 in the 1st or 5th character position from start code)

ECC-200 (FNC1 in the 2nd or 6th character position from start code)

Scanning enabled, without a check digit