Table of Contents
Advertisement
The indicator LED flashes in red when:
- no master data has been entered in the data verification mode.
The indicator LED flashes in orange when:
- the charge of the battery cartridge has lowered or
- the scanner turns itself off due to low charge of the battery cartridge.
The indicator LED lights in blue and orange alternately when:
- you switch between two readable codes or
- you switch between the normal reader mode and barcode reader mode.
You can disable the indicator LED with the QR-coded parameter menu or configuration software
(ScannerSetting_2D). Regardless of such setting, however, the indicator LED comes on when:
- the scanner is being customized with the QR-coded parameter menu,
- the scanner receives an LED-ON command (LB, LG or LR) from the host computer (refer to Appendix 2),
- the configuration software (ScannerSetting_2D) starts up or accepts any new setting,
- the scanner reads a batch-process QR Code symbol,
- a master code is being entered or the entry is completed,
- any error has occurred during entry of a master code,
- the verification result is a mismatch, the scanner is locked, or no master data has been entered in the data verification
mode,
- data transfer has been completed or there is no previous data to be retransferred using the data retransfer function,
- data transfer has been completed by the specific character transfer function,
- the setting status of the readable code switching function is displayed,
- you press the magic key that has been disabled by a control command (refer to Appendix 2) specifying any trigger
switch operating mode other than continuous reading modes 1 and 2 even though the ready/standby switching
function has been assigned to the magic key,
- the setting status of the barcode reader mode switching function is displayed,
- a hardware error has occurred.
- the Bluetooth
wireless link status is displayed,
- the charge of the battery cartridge has lowered,
- the charging/discharging state is displayed,
- the parameter transfer status from the scanner to the communications adapter is displayed, or
- the scanner failed to save setting.
37
Advertisement
Table of Contents
