Table of Contents
Advertisement
8.3
Vibrator
The QR-coded parameter menu and configuration software (ScannerSetting_2D) provide three configuration choices:
indicating successful scanning (OK), indicating an error (NG), and disabled.
"OK" vibrations: The vibrator operates to indicate any of the following OK conditions.
- Successful transmission of the code data just read
- In data verification mode, a match between the code data just read and a master data entry
- In data verification mode, successful entry of master data
- Scanning of a split QR Code symbol
- In batch edit mode, successful transmission of a sequence of split QR Code symbols
- End of data transmission started by the retransfer or specific character transfer function
- Scanning of "Start setting," "End setting," or parameter setting code from the QR-coded parameter menu (given in
Chapters 13 and 14)
- Start or end of parameter setting with the configuration software (ScannerSetting_2D)
- Scanning of a batch-process QR Code symbol generated with the configuration software (ScannerSetting_2D)
"NG" vibrations: The vibrator operates to indicate any of the following failure conditions.
- Wrong number of digits in data for new master data entry
- In data verification mode, a mismatch between the code data just read and a master data entry
- In edit mode, a sequence of split QR Code symbols containing over 8 kilobytes of data
- Detection of a code other than a parameter setting one during a parameter setting sequence using the QR-coded
parameter menu
- No ACK response received in the ACK/NAK mode
- Invalid control command (See Appendix 2)
- No data to resend (See the data retransfer function in Chapter 6)
- Timeout or other communications error during parameter setting with the configuration software
(ScannerSetting_2D)
- Depression of the magic key that has been disabled by a control command (refer to Appendix 2) specifying any
trigger switch operating mode other than continuous reading modes 1 and 2 even though the ready/standby
switching function has been assigned to the magic key
Note: It is recommended that the vibrator be disabled when the scanner is stationary to a stand.
38
Advertisement
Table of Contents
