To reboot the Radio Link Module from a remote location:
1. Start the RLM Manager program.
2. Select the target Access Point RLM from the list or enter the IP address
for a specific RLM.
3. Open the RLM menu.
4. Select
The RLM Manager program will now prompt you to enter the password
required to reboot the device.
5. Enter the Read/Write password and click
6. The Radio Link Module will restart and run the start-up diagnostics.
After approximately 15 seconds, the RLM will start bridging operation using
the configuration parameters as they were stored in the RLM prior to the
reboot.
If you would like to display the configuration file or monitor the Radio Link
Module's performance after a reboot, you may have to wait until the unit
completes the start-up diagnostics before you can access the Access Point
RLM again.
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
RLM.
.
243