The system information does not provide on-line statistics, but is primarily
used to verify the version level of the embedded software that is loaded into
the Access Point RLM.
To display the system information for the RLM, you must first connect to the
target RLM (see
Select the
•
The fields
been entered in the corresponding fields of the
mode when the Access Point RLM was configured.
If you would like to change these names, please consult the section
about configuring SNMP parameters as described in
(page
211).
•
The
time the Radio Link Module was reset. If the up time is lower than
expected, the RLM may have been reset manually or rebooted
automatically.
•
The fields
to end-users. You will need these values and the contents of the
problem.
Providing this information to your Technical Support representative will
help to determine the cause of the problem.
To do so, you can either:
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
Connecting to Access Points RLMs (page
tab to view the system information.
,
and
field displays the time interval measured from the last
and
field only when contacting Technical Support to report a
represent the values that have
SNMP Parameters
do not display relevant information
99)).
tab in the edit
101