Table of Contents
Advertisement
i
The settings
RLMs require a excellent quality of radio communications
throughout the entire wireless coverage area. In environments
where the actual placement of Radio Link Modules was designed to
obtain maximum wireless coverage with a minimum number of
Access Point RLMs, changing the distance between RLMs from
doing so might seriously affect the roaming performance of your
wireless stations, risking network communication errors caused by
"out-of-range" situations.
If you consider using the option
Link Modules to create a high performance network, you are advised to read
the section
Frequency Channel Management (page 138)
For more information about Access Point RLM density, please consult
Optimizing Performance (page
The Multicast Rate identifies the preferred transmission speed for your
Access Point RLM broadcast traffic as forwarded by the Radio Link Module.
Where transmissions at lower data rates are usually more reliable, you may
prefer higher throughput performance over greater coverage for your
wireless radio signal.
For more information about multicast rate refer to the help-file of the
RLM Manager program.
196
or
to
or
116).
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
distance between Access Point
will not yield better results. Adversely,
or
distance between Radio
as well.
C79000-G8976-C171-01
Advertisement
Table of Contents
