Related Manuals for True SPECTRUM ELLIPTICAL XS1000
Summary of Contents for True SPECTRUM ELLIPTICAL XS1000
- Page 1 * Assembly Guide & Warranty Card Included SPECTRUM ELLIPTICAL OWNER’S MANUAL Model# XS1000 Revision 091418...
- Page 2 SPECTRUM ELLIPTICAL OWNERS MANUAL IMPORTANT: All products shown are prototype. Actual product delivered may vary. Product specifications, features & software are subject to change without notice. For the most up-to-date owner’s manual please visit www.truefitness.com. For documents in additional languages please visit www.truefitness.com/resources/document-library/ IMPORTANTE: Todos los productos mostrados son prototipos.
- Page 3 The proud manufacturing tradition of quality and the culture of innovation at TRUE have given rise to a full line of extraordinary cardio and strength equipment. As a result, people all over the world are benefiting from the TRUE experience.
-
Page 4: Table Of Contents
SPECTRUM ELLIPTICAL OWNERS MANUAL TABLE OF CONTENTS: Chapter 1: Safety Instructions Safety Instructions ..................................5 Space Requirements ................................8 Elliptical Entry and Exit Safety .............................8 Grounding Instructions .................................9 Power Requirements ................................10 Warning Decals..................................11 Compliances ..................................11 Proper Training Position ..............................11 Chapter 2: Assembly Instructions Pre Assembly Checklist ...............................13 Assembly Steps ..................................14 Wiring Diagram..................................23... -
Page 5: Chapter 1: Safety Instructions
45, smokes, has high cholesterol, is obese or has not exercised regularly in the past year. Additionally, TRUE recommends consulting a fitness professional on the correct use of this product. - Page 6 To disconnect, turn power OFF at the ON/OFF switch if applicable, then remove plug from electrical outlet. • Never operate a TRUE product if it has a damaged power cord or electrical plug, or if it has been dropped, damaged, or even partially immersed in water. Contact TRUE Customer Service for a replacement.
- Page 7 Never insert objects into any openings in this product. If an object should drop inside, turn off the power, unplug the power cord from the outlet and carefully retrieve it. If the item cannot be reached, contact TRUE Customer Service.
-
Page 8: Space Requirements
CHAPTER 1: SAFETY INSTRUCTIONS SPACE REQUIREMENTS: TRUE’s recommendation is to leave a 39” (0.9m) safety zone at rear of elliptical. The sides of the unit should be at least 24” (0.6m) away from the wall or obstructions. (See Fig 1) -
Page 9: Grounding Instructions
CHAPTER 1: SAFETY INSTRUCTIONS GROUNDING INSTRUCTIONS: This product must be grounded, if it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. -
Page 10: Power Requirements
CHAPTER 1: SAFETY INSTRUCTIONS Truefitness.com / 800.426.6570 / 636.272.7100 10 of 36... -
Page 11: Warning Decals
WARNING DECALS: WARNING: Replace warning labels that may be worn, damaged, or missing. To replace any worn or missing decals contact TRUE FITNESS by visiting www.truefitness.com or contact customer service at 800-883-8783. COMPLIANCES: This equipment complies with all applicable codes and regulations. For a complete list of compliances, please visit www.truefitness.com. - Page 12 CHAPTER 2: ASSEMBLY GUIDE IMPORTANT SAFETY INSTRUCTIONS • Read and understand all instructions and warnings prior to use. • Obtain a medical exam before beginning any exercise program. If at any time during exercise you feel faint, dizzy, or experience pain, stop and consult your physician. •...
-
Page 13: Pre Assembly Checklist
CHAPTER 2: ASSEMBLY GUIDE PRE-ASSEMBLY CHECK LIST: Tools Required (not included): • Phillips screwdriver • M6 Hex Key • M8 Hex Key • M10 Hex Key • 17mm wrench CAUTION: • It is recommended that two people unpack and assemble elliptical. •... -
Page 14: Assembly Steps
CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: Measure Doorways: Measure all doorways, hallways and stairwells to make sure that the 34.5” frame can fit through them. If it will not fit, move all parts to the final location and assemble machine in that location. If the machine needs to be placed on its side, separate the upper pedestal from the base and keep the left side foam packaging attached to the base to help avoid damaging the plastic covers as shown. - Page 15 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 1 Fold Up and Install Pedestal: a) Remove the container lid and top layer of parts and packaging. b) Remove all loose parts and packaging materials. c) Leave the machine base on the shipping container until Step 3.
- Page 16 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 3 Remove Unit from Pallet: a) Using the Step up tube, lift the unit at the rear. b) Carefully walk the unit forward to remove it from the pallet. STEP 4 Route Cable and Install Console Mast: a) Slide the USB data cable through the opening in the Console Mast toward the front of the machine (in the direction of the arrow shown to the right).
- Page 17 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 5 Install Heart Rate Handle Bars: a) Connect Cardio Arm Heart Rate Cable. b) CAREFULLY slide the handle bar onto Pedestal and tuck the Heart Rate Cable into the metal tube. Make sure to not pinch the heart rate wires.
- Page 18 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 7 Connect Cables & Install Exercise Arm Covers: a) Connect remote access key cable at the base of each Upper Exercise Arm. b) Attach the Exercise Arm Covers using 2 M5 0.8 x 25mm and 1 M5 0.8 x 12mm screws per side.
- Page 19 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 9 Install Chin-Bar Covers and Gasket: a) Attach the inner and outer chin-bar covers using 6 M5 0.8 x 12 mm screws Short Screw and 1 M5 0.8 x 50 mm screw. *Screw locations shown on the right. b) Slide the black rubber gaskets down the pedestal uprights until they are snug against the newly installed chin bar covers.
- Page 20 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 10 Install Draw-Bars: b) Slide each drawbar onto its shaft and install and fully tighten M10 1.5x75mm bolt, flat washer and M10 nut with a 17mm socket and wrench. c) Tighten the bottom 8 bolts with 6mm allen wrench.
- Page 21 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 12 Install Pedal Tube Plastic Knuckle Covers: a) Attach the front pedal tube covers using 8 M5x12mm screws. Hardware Required: 8 M5 x 12 mm bolts *DO NOT use an impact drill when assembling plastic components.
- Page 22 CHAPTER 2: ASSEMBLY GUIDE ASSEMBLY STEPS: STEP 14 Attach Rear Console Plastic: a) Attach the Rear Console Cover using one M5 08.x12mm bolt. Hardware Required: 1 M5 0.8 x 12 mm bolts *DO NOT use an impact drill when assembling plastic components. STEP 15 Floor Levelers: a) If necessary, adjust 3 levelers on bottom of machine to accommodate...
-
Page 23: Wiring Diagram
CHAPTER 2: ASSEMBLY GUIDE WIRING DIAGRAM: Truefitness.com / 800.426.6570 / 636.272.7100 23 of 36... -
Page 24: Exploded Diagram
CHAPTER 2: ASSEMBLY GUIDE EXPLODED DIAGRAM: Truefitness.com / 800.426.6570 / 636.272.7100 24 of 36... -
Page 25: Product Overview
CHAPTER 3: PRODUCT OVERVIEW SPECTRUM OVERVIEW: Upper Exercise Arms Quick Access Keys Console Assembly Contact Heart Rate Pads Foot Pads Side Steps Coaxial Port Ethernet Port Power Cord Leveling Feet Truefitness.com / 800.426.6570 / 636.272.7100 25 of 36... - Page 26 CHAPTER 3: PRODUCT OVERVIEW SPECTRUM OVERVIEW: Console Assembly: The console allows the user to set up a workout program and control the elliptical during a workout (For console overview and operation instructions refer to the owner’s manual for the selected console option). Upper Exercise Arms: Moving handles on the elliptical that provide resistance to the upper body during a workout.
-
Page 27: Chapter 4: Care & Maintenance Care & Maintenance
CAUTION: Do not use any acidic cleaners. Doing so will weaken the paint or powder coatings and may void the TRUE Fitness Warranty. Never pour water or spray liquids on any part of the elliptical. Allow the elliptical to dry completely before using. -
Page 28: Other Scheduled Preventive Maintenance
CHAPTER 4: CARE & MAINTENANCE OTHER SCHEDULED PREVENTIVE MAINTENANCE: TRUE recommends that quarterly scheduled maintenance be performed by a qualified service technician. Please contact your dealer or visit www.truefitness.com to contact a local TRUE authorized service technician. Scheduled Preventive Maintenance: •... -
Page 29: Chapter 5: Customer Service
HOURS OF OPERATION: 8:30 A.M. - 5:00 P.M. CST E-MAIL: service@truefitness.com CONTACTING SALES: Interested in TRUE Products? Please contact us with any sales or product inquires so that we may direct you to the appropriate sales representative to answer your questions. TRUE FITNESS HOME OFFICE 865 HOFF ROAD ST. -
Page 30: Reporting Freight Or Parts Damage
Please make sure the photos include the damaged product as well as the damaged box the product arrived in. Contact the TRUE Fitness customer support team by calling 800.883.8783 or sales support team by calling 800.426.6570 Monday-Friday during normal business hours. -
Page 31: Chapter 6: Additional Information
This troubleshooting guide is intended to assist in diagnostics only and is not all inclusive. Technical specifications, error codes and programming are subject to change without notice. TRUE accepts no liability for any damage or loss suffered by persons whom rely wholly or in part on any description or statement contained within this manual. Please visit www.truefitness.com for current product manuals and contact the TRUE Service Department at 800-883-8783 for... - Page 32 Channels or format type not correct Rescan TV channels Tuner Invalid Contact TRUE Fitness Customer Service Department Transmitter belt contacts are not Re-adjust the transmitter belt so that it is in full contact with the making good contact with the skin...
- Page 33 Re-configure console Invalid Console Console failed validation checks (incline ranges make no Configuration Loose cable Contact dealer or TRUE service sense, etc.) Fault CN03: Membrane Key stuck Membrane key is Console Contact dealer or TRUE service Stuck Key down/closed...
-
Page 34: Chapter 7: Warranty Information
Product. The frame is warranted for labor and freight (for parts whom the Product was purchased. If the dealer from whom shipped from TRUE) for two years from date of purchase. * This the Product was purchased is no longer an authorized TRUE... -
Page 35: Warranty Registration
OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL attached form is filled in, signed by the original purchaser and mailed to TRUE within 30 days of purchaser’s receipt of this DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY Product. The serial number must be intact on the Product for NOT APPLY TO YOU. - Page 36 If you prefer to mail your warranty card, have the owner of the product complete the information below and return it to TRUE Fitness within 30 days from the date of equipment installation.